RS Pro T.PW60.80 Электронный трансформатор с регулируемой яркостью,
Техническая документация
Характеристики
Brand
RS ProТип продукции
Light Transformer
Первичное номинальное напряжение
220 to 240 V
Вторичное напряжение
11.5 to 12 V
Minimum Load Requirement
10W
Максимальная рабочая температура
45°C
Минимальная рабочая температура
-20°C
Подтип
Electronic
Тип оконцовки
Винт
Тип монтажа
Винтовая клемма
Ширина
31 mm
Глубина
20мм
Длина
86мм
Вес
50g
Стандарты/одобрения
EN 61347-1, EN 61047, EN 60598-1, EN 55015, EN 61000-3-2, VDE 0710-T14, EN 61547, EN 61347-2-2
Серия
PW 60
Dimming Method
Trailing Edge
Максимальная рабочая частота
60Hz
Минимальная рабочая частота
50Hz
Страна происхождения
Italy
Информация о товаре
Dimmable Electronic Mini Transformer - PW60
IP20 rated independent transformer for 12V halogen lamps.
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.
Информация о наличии не успела загрузиться
тг 3 383,79
тг 3 383,79 Each (ex VAT)
1
тг 3 383,79
тг 3 383,79 Each (ex VAT)
Информация о наличии не успела загрузиться
1
Техническая документация
Характеристики
Brand
RS ProТип продукции
Light Transformer
Первичное номинальное напряжение
220 to 240 V
Вторичное напряжение
11.5 to 12 V
Minimum Load Requirement
10W
Максимальная рабочая температура
45°C
Минимальная рабочая температура
-20°C
Подтип
Electronic
Тип оконцовки
Винт
Тип монтажа
Винтовая клемма
Ширина
31 mm
Глубина
20мм
Длина
86мм
Вес
50g
Стандарты/одобрения
EN 61347-1, EN 61047, EN 60598-1, EN 55015, EN 61000-3-2, VDE 0710-T14, EN 61547, EN 61347-2-2
Серия
PW 60
Dimming Method
Trailing Edge
Максимальная рабочая частота
60Hz
Минимальная рабочая частота
50Hz
Страна происхождения
Italy
Информация о товаре
Dimmable Electronic Mini Transformer - PW60
IP20 rated independent transformer for 12V halogen lamps.
Low Voltage Lighting Transformers
Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.
Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.